-
-
Heat
Aneroid Calorimeter
This calorimeter features an advanced insulated outer wall that delivers nearly five times the sensitivity of standard models. The central chamber is made of aluminum and is fully enclosed within a thick Styrofoam insulation layer; all housed inside a strong plastic casing to minimize heat transfer and ensure very low heat loss during experiments. Key features include:
- Aluminum inner chamber for accurate thermal measurement
- Multi-layer insulation with Styrofoam for superior heat retention
- Robust plastic exterior for added durability and reduced heat flow
- Compatibility with specific heat cylinder sets for thermal property studies
Accessories (Not included): Specific Heat Cylinders Set (PH20183)
PH20178 -
Heat
Immersion Heater
Specially designed for metal block calorimeters. The heating element is enclosed in a stainless-steel tube with two connecting leads, insulated with heat-resistant insulation. The stainless-steel enclosure features a sealed base to prevent water leakage and a threaded cap at the opposite end for the insertion of a porcelain pipe. Rated at 12 V, 50 W.
PH20185S -
-
Heat
Specific Heat Demonstration Set
Unique way to illustrate the different heat capacities of various metals features a slanted panel with four grooves to hold four different metals. Place a sheet of bee’s wax in the front of the pane and submerge the metal samples in hot water. When the metals are placed on the grooves simultaneously they will melt and sink through to different levels based on their specific heat. Includes four metals cylinders: Aluminum, Copper, Lead and Tin; support stand, two pieces of beeswax and instructions.
PH20202 -
Heat
Steam Generator
Seamless construction, Safer than traditional models, features a tripod base that dissipates heat more evenly and efficiently. The base and legs are of chrome plated steel for heat and corrosion resistances are also unlikely to melt if the unit is used improperly. Supplied with instructions.
PH20220 -
Heat
Steam Heater
Copper cylindrical vessel 180 x 115 mm with steam vent and a vertical tube terminating in chute passing through side of vessel. A brass tube sliding fit in the central tube, with lower angle cut to seal the chute, enables heated material to be transferred to calorimeter without loss of heat.
PH20230
+1 (630) 345-3450